Physical-Chemical Characterization of Activated Charcoal from Coconut Shells as an Adsorbent in Reducing Ammonia (NH₃) Content in Nickel Industry Liquid Waste

Authors

  • Resti Ayu NIngrum Program Studi Teknik Listrik dan Instalasi, Akademi Komunitas Industri Manufaktur Bantaeng, Indonesia
  • Rismul Trianto Salawali Program Studi Analisis Kimia, Akademi Komunitas Industri Manufaktur Bantaeng, Indonesia
  • Maipha Deapati Arief Program Studi Analisis Kimia, Akademi Komunitas Industri Manufaktur Bantaeng, Indonesia
  • Jamaluddin Gesrianto A’Ban Program Studi Analisis Kimia, Akademi Komunitas Industri Manufaktur Bantaeng, Indonesia
  • Saparullah Saparullah Program Studi Teknik Listrik dan Instalasi, Akademi Komunitas Industri Manufaktur Bantaeng, Indonesia
  • Alfridha Dwi Putri Program Studi Teknik Listrik dan Instalasi, Akademi Komunitas Industri Manufaktur Bantaeng, Indonesia

Keywords:

Ammonia, Activated Carbon, Liquid Waste, Coconut Shell

Abstract

This research aims to evaluate the effectiveness of activated charcoal produced from coconut shells in reducing ammonia (NH3) levels in domestic wastewater. Liquid waste containing ammonia can cause environmental pollution and negatively impact ecosystems. Therefore, an efficient method is needed to reduce ammonia levels. In this study, activated charcoal was made through the carbonization process of coconut shells and tested for its ability as an adsorbent. The research was conducted experimentally with variations in the mass of activated charcoal of 600 mg, 800 mg, and 1 g. The research results show that coconut shell activated charcoal meets the specifications of Indonesian Industrial Standard (SNI No. 06-3730-1995) with a moisture content of 3%, ash content of 6%, volatile matter content of 14%, and pure activated carbon content of 77%. The reduction in ammonia content obtained was 59.76% for a mass of 600 mg, 61.1% for a mass of 800 mg, and 67.59% for a mass of 1 g. These results indicate that activated coconut shell charcoal has good potential as an adsorbent for the treatment of liquid waste containing ammonia. This research is expected to contribute to the development of more environmentally friendly waste treatment technologies and the sustainable use of local resources.

Downloads

Download data is not yet available.

References

Arsad, E. (2010). Teknologi Pengolahan Dan Pemanfaatan Karbon Aktif Untuk Industri. Jurnal Riset Industri Hasil Hutan, 2(2), 43

Bagas, A.M. (2021). Analisis Kualitas Arang Aktif Ampas Kopi (Coffea) sebagai Adsorben Dalam Penurunan Kadar Amonia pada Limbah Cair Industri di PT. KIMA (Persero). Makassar. Kementrian Perindustrian R.I Politeknik Makassar.

Benefield, L. D., & Randall, W. C. (1980). Biological Process Desain for Wastewater Treatment Prentice. USA: Hall Inc.

Cobb, A., Warms, M., Maurer, E. P., & Chiesa, S. (2012). Low-Tech Coconut Shell Activated Charcoal Production.

International Journal for Service Learning in Engineering, Humanitarian Engineering and Social Entrepreneurship, 7(1), 93– 104.

Dahlan, M. H., Siregar, H. P., & Yusra, M. (2013). Penggunaan Karbon Aktif Dari Biji Kelor Dapat Memurnikan Minyak Jelantah. Jurnal Teknik Kimia, 19(3), 44– 53

Dewi, T. K., Nurrahman, A., & Permana, E. (2009). Pembuatan Karbon Aktif dari Kulit Ubi Kayu (Mannihot esculenta). Jurnal Teknik Kimia, 16(1), 24–30.

Dhana, R. R., Riza, A. K., (2019). Fly ash Tempurung Kelapa Sebagai Bahan Tambah pada Beton Non Struktural. Jurnal Teknik Sipil Universitas Teuku Umar, 5(2), 121–127.

Hassler, J. W. (1974). Purification With Activated Carbon : Industrial commercial, Enviromental. New York: Chemical Publishing Co. Inc.

Lam, S. S., & Chase, H. A. (2012). A review on waste to energy processes using microwave pyrolysis. Energies, 5(10), 4209–4232.

Manocha, S. (2003). Porous Carbon. Sadhana 28, 335-348.

Marina Olivia Esterlita, & Netti Herlina. (2015). Pengaruh Penambahan Aktivator ZnCl2, KOH, Dan H3PO4 Dalam Pembuatan Karbon Aktif Dari Pelepah Aren (Arenga Pinnata). Jurnal Teknik Kimia USU, 4(1), 47–52.

Meisrilestari, Y., Khomaini, R., & Wijayanti, H. (2013). Pembuatan Arang Aktif Dari Cangkang Kelapa Sawit Dengan. Konversi, 2(1), 46–51.

Murti, R. S., & Purwanti, C. M. H. (2014). Optimasi waktu reaksi pembentukan kompleks indofenol biru stabil pada uji n-amonia air limbah industri penyamakan kulit dengan metode fenat. Majalah Kulit, Karet, Dan Plastik, 30(1), 29.

Murti, S., & Maria. (2014). Optimasi Waktu Reaksi Pembentukan Kompleks Indofenol Biru Stabil Pada uji N-Amonia air Limbah Industri dengan Metode Fenat. Majalah Kulit, Karet dan Plastik, Vol.30 No 1 : 29-34

Peraturan Pemerintah NO. 82 . (2001). Tentang Pengelolaan Kualitas Air dan Pengendalian Pencemaran Air.

Syauqiah, I., Amalia, M., & Kartini, H. A. (2011). Analisis variasi waktu dan kecepatan pengaduk pada proses adsorpsi limbah logam berat dengan arang aktif. Info-Teknik, 12(1), 11-20

Widayat, w., Suprihatin, & Herlambang, A. (2010). Penyisihan Amonia dalam upaya meningkatkan kualitas air baku PDAM-IPAL bojong renged dengan proses Biofiltrasi menggunakan media plastic tipe sarang tawon. Jurnal Air Indonesia, 64-76.

Downloads

Published

2025-02-27

How to Cite

NIngrum, R. A., Salawali, R. T., Arief, M. D., A’Ban, J. G., Saparullah, S., & Putri, A. D. (2025). Physical-Chemical Characterization of Activated Charcoal from Coconut Shells as an Adsorbent in Reducing Ammonia (NH₃) Content in Nickel Industry Liquid Waste. Jurnal Sains Dan Teknik Terapan, 3(1), 17–24. Retrieved from https://journal.akom-bantaeng.ac.id/index.php/jstt/article/view/73